Search results

Create the page "Engine" on this wiki! See also the search results found.

• EFI Harness
  ...connectors connecting the [[ECU]] to various components in and around the engine bay.<br /> <br /> <br /> <br /> <br /> <br /> * [[Engine Temp Sensor]]
  2 KB (393 words) - 21:57, 5 April 2018
• EGR Removal
  # The bolts that hold the EGR valve to the engine are longer than the space between the EGR valve and the firewall. ===Engine-rocking Method===
  7 KB (1,187 words) - 21:57, 5 April 2018
• EPROM
  On the Z32's [[ECU]], the EPROM contains information essential to the engine's operation. Fuel injector timing and pulse widths, ignition timing, speed
  2 KB (323 words) - 21:57, 5 April 2018
• Electronic Boost Controller Supplement
  ...ng faster and faster and could result in too much boost, which would cause engine components to fail. To regulate the amount of boost, wastegates are equippe
  7 KB (1,183 words) - 21:57, 5 April 2018
• Electronic Fuel Injection
  ...asure the amount of fuel required by an engine, and then deliver it to the engine.<br /> EFI became popular in the 1980s. Practically all modern cars today * The rotational speed and position of the engine is measured by the CAS and sent to the ECU.
  3 KB (567 words) - 21:57, 5 April 2018
• Engine Fuel & Emissions Control
  ...ctronic concentrated control unit (ECCS, or colloquially called the ECU or Engine Control Unit).<br /> <br /> This section is primarily based on the Parts D ...ted Control System) is the primary computer used in the Z32 to control the engine and various other components in the car necessary to it running properly. P
  7 KB (1,285 words) - 21:57, 5 April 2018
• Fan Clutch
  ..." and lets the fan free-spin slightly, which reduces parasitic draw on the engine.<br /> ...clutch is directly driven by the engine, it generates a small draw on the engine due to drag created by the fan blades. This, coupled with the high cost of
  6 KB (919 words) - 21:57, 5 April 2018
• Flywheel
  ...A '''Flywheel''' is a device attached to the rear of the crankshaft on the engine. It provides three main functions for the car: *Provide a way for the [[Starter|starter]] to rotate the engine.
  3 KB (372 words) - 18:56, 9 November 2018
• Fuel Injector
  ...s a device used to inject a specified amount of fuel into the intake of an engine as air enters a cylinder, creating the '''air/fuel mixture'''.<br/> Fuel in ...fit P2 heads. The (proper) possible ways to install P2 injectors into a P1 engine are:
  15 KB (2,202 words) - 17:50, 26 October 2021
• Fuel Injector O-Rings
  ...660000">[[Hydrolock|hydrolock]]</span> the motor, which can cause complete engine failure.<br /> Main Article: [[Fuel Injector Replacement]].<br />
  2 KB (255 words) - 21:57, 5 April 2018
• Fuel Injector Replacement
  ...engthy process that involves removal (and reinstallation) of various vital engine components, some opt for the messier Dremel Method when replacing injectors # While twisting, gradually pull up (away from the engine). It will likely take quite a bit of effort.<br /> [[File:grab~injctr~w~pli
  7 KB (1,244 words) - 21:57, 5 April 2018
• Fuel Pressure Relief
  # Crank the engine over. The engine will likely start. # Wait for the engine to die (if it starts). Crank it over an additional 5-10 seconds.
  3 KB (564 words) - 21:57, 5 April 2018
• Fuel Pump
  ...In carbuerted vehicles, fuel pumps are often mechanical and mounted to the engine. In modern fuel-injected cars, fuel pumps are almost always mounted directl # Crank the engine (attempt to start). You'll need a helper if you have a 2+2 unless you have
  9 KB (1,492 words) - 21:57, 5 April 2018
• Fuel Pump Control Unit
  * Engine cranking. * 30 seconds (NA) or 5 seconds (TT) after engine starts above 122°F.
  5 KB (875 words) - 21:57, 5 April 2018
• Fuel Rail
  ...uit various engine configurations (such as installing P2 injectors in a P1 engine).
  2 KB (324 words) - 21:57, 5 April 2018
• Fuel System Diagram
  ...block"> This diagram illustrates the routing of the fuel components in the engine bay of the Z32.<br /> <br />
  294 bytes (45 words) - 21:57, 5 April 2018
• Fuel Temp Sensor
  ...o determine whether or not to activate the PRVR Solenoid when starting the engine. <br /> <br /> It uses the same voltage - temperature conversion as the [[
  1 KB (185 words) - 21:57, 5 April 2018
• Gauge Cluster
  * Engine RPM (0-9000 RPM) * Engine Oil Pressure
  7 KB (1,086 words) - 21:57, 5 April 2018
• Glossary
  ...air through the downward intake stroke of the 4-stroke internal combustion engine.<br /> ...ngle turbo [http://en.wikipedia.org/wiki/Nissan_VG_engine#VG30DET VG30DET] engine, which was sold in various Japan-only cars (Nissan Cedric, Gloria, Cima, an
  3 KB (523 words) - 21:57, 5 April 2018
• HICAS
  ...towards each other (to keep the rack centered). When the solenoids in the engine bay opened, they allowed hydraulic pressure through the lines to either sid ...ame identical to that found in the NA (all years), heavily simplifying the engine bay. This newer version used electric motors at the rear of the car to actu
  4 KB (747 words) - 21:57, 5 April 2018

View (previous 20 | next 20) (20 | 50 | 100 | 250 | 500)