⚠
Prop 65 Hazardous Material Warning
Some products are manufactured using chemicals or materials known to the state of California to cause cancer and/or reproductive harm. Learn More.
Description
If
you
are
permanently
removing
the
EGR
system
from
your
engine,
this
kit
will
make
it
easy
to
plug
the
holes.
Z32
EGR
Removal
Kit
consists
of
2
plates
and
gaskets
to
block
the
openings
on
the
bottom
of
the
intake
plenum,
a
special
bolt
to
replace
the
EGR
valve
exhaust
fitting
and
a
cap
for
the
EGR
vacuum
line.
This
kit
is
NOT
for
on-road
use.
It
is
intended
to
be
a
clean
solution
for
removing
the
EGR
system
on
race-built,
race-tuned
engines.
Compatibility
If you have questions about vehicle fitment, please contact us.
Customer Questions
Question:
Hello, I bought this kit from you. 1 questions? where do these 2 rubber go? i'm going crazy :D do you have a drawing ? I don't understand the diagram very well. or can you draw it there? greetings chris
- Christopher
Answer:
Hi Christopher, one goes on the vacuum port on the underside of the passenger side throttle body. The other is only used if you're maintaining your AIV system, as they share vacuum lines, so you can off the line that used to go to the EGR solenoid.
Reviews
Rated 5/5
based on 1 customer reviews
Solid kit. Fits as it should. I opt to remove the EGR nipple from the throttle body and tap it with an M6x1.0 thread and then install a short M6 bolt with thread lock. I find the caps like to rip or fall off.
