Works Bell short hub kits are exclusive to RAPFIX II or GT-C’s. These are not recommended to use by themselves, because it will be far too short and knuckles will possibility hit blinker / windshield washer switches. Note that as these intended for the Japanese market, their airbag setup is slightly different. These include a single male resistor, but most USDM cars will require two resistors.

This hub adapter is 65mm in depth, and 26mm shorter than the "standard" equivalent.

Steering Wheel Fitment Explained

Aftermarket steering wheels are "universal" (not vehicle specific), but will require a hub adapter that is compatible with your vehicle and has the correct bolt pattern for your steering wheel. There are two bolt patterns in common use today:

• 6x70mm PCD - NRG, OMP, Sparco, MOMO, Grip Royal, Works Bell
• 6x74mm PCD - Nardi, Personal

Hub adapters with 12 bolt holes typically support both of the above patterns. However, "short" hubs, and quick release adapters (which are optional), often only support one of the two above patterns, so be sure to double check that all of your components are compatible with one another.