TI Automotive's new in-tank brushless fuel pump utilizes advanced technology for maximum reliability and efficiency. The result is a next-generation pump for any type of engine offering precise control of fuel pressure, lower current draw, reduced heat and less noise. Supporting up to 1000+ HP, the BKS1001 provides more power, more torque and more speed. Matched controller with simple power and ground operations for easy maintainability. The controller features sealed electronics for weather resistance.

This kit includes many components including an E5LM submersible brushless fuel pump and controller. These two items are NOT available separately. The pump is an efficient screw pump design with positive displacement that is designed for in-tank installation only.

The BKS1001 does support variable speed control with compatible ECUs/controllers, by way of pulse width modulation, allowing it to reduce its output to less than half of its maximum. Input signal:

INPUT SIGNAL:
1. The controller requires a squarewave frequency (battery voltage to ground) at 100Hz.
2. When the duty cycle input is between 95-100%, the controller will output a 100% duty cycle signal to the pump.
3. When the duty cycle input is between 10-95%, the controller will output a linear transfer function though this range.
4. When the duty cycle input is less than 1-4%, the controller will output a 0% duty cycle signal to the pump.
5. When the signal wire is simply grounded, the controller will output a 45% duty cycle signal to the pump.

If no input signal is connected, the controller will run at 100% speed.

All sealed weather resistant electronics with 3ft wiring leads. Includes a 31 micron inlet filter. Can be run with 8 to 18 volts DC, however the speed of the pump will change accordingly.

Compatible with gasoline, ethanol, and blends (E85 etc).

Please note this pump does NOT have an integrated check valve. If needed, Radium 20-0598 works great.