If you want to use one of our super dooper awesome clutch fans on your RB/VG series motor then you will need to use one of these billet aluminium adapters. The PCD, bore size and the offset all differ from the SR to the RB/VG but this adapter is hub centric and leaves only a 0.07'' offset variance when compared to your standard RB/VG clutch fan with the standard clutch. Ie. it means that the fan will sit 0.07'' closer to the radiator when using our clutch fan with this adapter.

Our clutch fan is a proven performer with over 800 satisfied customers using these on the SR20's and compared to the RB/VG clutch fan you will see an increase in air flow of around 40% which is easily noticeable the second that you install the fan.

Vehicle Compatibility: - Nissan Skyline R31 RB30E - Nissan Skyline R32 GTS-T - Nissan Skyline R32 GTS4 - Nissan Skyline R32 GTR - Nissan Skyline R33 GTS-T - Nissan Skyline R33 GTS4 - Nissan Skyline R33 GTR - Nissan Skyline R34 GT-T - Nissan Skyline R34 GTR - Nissan Cefiro A31 - Nissan 300ZX

NOTE: Will not fit VL RB30's as they use a different clutch pack to the R31 RB30 motor

NOTE #2: The diameter of the fan is the same as an RB clutch fan (16.92'') and if your intercooler piping runs over the area that the clutch fan sits and you had to trim the standard clutch fan to get it to fit, then this fan will also have this issue and it is strongly advised to NOT trim the clutch fan as it can become unstable and break off causing significant damage. When installing the fan ensure that there is atleast 0.39''-0.78'' clearance between the fan and anything around it, keeping in mind that your engine moves when under acceleration and braking.