Looks like you're using an unsupported browser, so some features might not work. We recommend upgrading your browser for a better experience.

Link Engine Management Plug-In ECU (Manual Transmission ONLY) - Toyota MR2 V1 & Celica ST185

Manufacturer: Link Engine Management
Product # {{ productPartNumber }}

$ 1,350 00

Manufacturer: Link Engine Management
Product # {{ productPartNumber }}

No Customer Questions Yet

Have any questions about this product? Ask a question here.

Ask a Question

No Reviews Yet

Be the first to tell the world about this product.

Login to Write a Review
Shipping Included

$ 1,350 00

Description

Easy to install. Affordable. Reliable.

G4X PlugIn ECUs offer the latest in engine management technology, designed to easily maximize the potential from your car. This ECU fits inside the factory OEM enclosure. Installation is a breeze, with no alteration of the factory wiring loom required for the models listed below.

Designed for the 3SGTE engine.

  • Please check your connector matches the header in the listed photo before purchasing.
  • This ECU works with manual transmissions ONLY.
  • Most factory features are supported.
  • Check the features for I/O expansion options
  • A Link Air Temp Sensor is highly recommended with this ECU
Suitable Applications


Toyota MR2 (SW20) from 1989 to 1992
Toyota Celica ST185 (except the Carlos Sainz special edition)

G4X PlugIn Key Features (where applicable):
  • Up to 6D fuel and ignition mapping
  • Precision closed loop cam control (four cam, independent control)
  • Sequential fuel delivery
  • Digital triggering, all OEM patterns
  • OEM idle hardware supported
  • 5D boost control with three switchable tables
  • Motorsport features - antilag, launch, flat shift
  • Continuous barometric correction (on board)
  • CAN port
  • QuickTune - automated fuel tuning
  • Individual cylinder correction
  • USB tuning cable included
  • Stats recording into on-board memory
  • Gear compensations for spark, boost and fuel
  • Real time selectable dual fuel, ignition and boost maps
  • Sync and crank sensors can be a combination of Hall effect, variable reluctance or optical
  • Boost control referenced to gear, speed or throttle position
  • 512 MB data logging memory
  • Staged injection
  • Knock with "windowing"
I/O Expansion Options:

The following expansion connector inputs/outputs are provided:
Expansion connector 1

  • Gnd - Sensor Ground Only
  • +5V Out - Low Current +5V Supply
  • DI 5 - Digital Input
  • DI 6 - Digital Input
  • DI 4 - Digital Input
  • An Volt 4 - Analog 0-5V input
  • An Volt 5 - Analog 0-5V input
  • An Volt 6 - Analog 0-5V input


An ignition expansion is provided allowing you to convert to a Direct Spark ignition system. Alternatively, these outputs can be used to drive auxiliary devices. The following pinout describes the available connections.

  • 1 Ignition 1
  • 2 Ignition 2
  • 3 Ignition 4
  • 4 Ignition 3

No Customer Questions Yet

Have any questions about this product? Ask a question here.

Ask a Question

No Reviews Yet

Be the first to tell the world about this product.

Login to Write a Review

Copyright 2024 Concept Z Performance